Core Function BinaryCompare

BinaryCompare( <binary-array>, <offset>, <needle, <needleOffset>, <length>, <ignoreCase> )

Description

Compare two binary variables.

Parameters

binary-array

The a binary variable to use.

offset

Optional; Start position to begin comparing. (0 = first byte)

If the offset is a negative value the position will work backwards from the length of the binary.

needle

The a binary variable to be comparing to.

needleOffset

Optional; Start position to begin comparing in the needle. (0 = first byte)

If the needleOffset is a negative value the position will work backwards from the length of the needle binary.

length

Optional; Maximal number of bytes to compare.

Default is the entire remainder of the shortest binary variable.

If length is given and is negative, then that many bytes will be omitted from the end of binary (after the start position has been calculated when a start is negative).

If start denotes the position of this truncation or beyond, failure will be returned ( -2 ).

The length will be calculated separately for the binary and the needle then the shortest of the two will be used.

ignoreCase

Optional; if true the comparison is case-insensitive

Return Value

-1 if binary1 is less than binary2

1 if binary1 is greater than binary2

0 if they are equal.

-2 on error

Remarks

If ignoreCase is true, the result is equivalent to performing a case-sensitive comparison after converting the uppercase ASCII letters A-Z in both binary variables to lowercase.

Example

my $Binary1 = Pack("A*", "Hello world!!!");
my $Binary2 = Pack("A*", "Hello world!!!");
 
If( BinaryCompare($Binary1, 0, $Binary2) == 0 )
{
	println("Both binary variables contain the same data");
}
Else
{
	println("No match");
}
 
println("");
println("Lets try again now now that one was changed");
my $Binary1 = Pack("A*", "Test");
If( BinaryCompare($Binary1, 0, $Binary2) == 0 )
{
	println("Both binary variables contain the same data");
}
Else
{
	println("No match");
}

Check from the 4th byte to the 6th byte

my $Binary1 = Pack("A*", "TheFoXok");
my $Binary2 = Pack("A*", "DatFoXNP");
 
If( BinaryCompare($Binary1, 0, $Binary2, 3, 3) == 0 )
{
	println("Both binary variables contain the same data");
}
Else
{
	println("No match");
}