Core Function BinaryCompare

Revision as of 09:41, 2 August 2014

BinaryCompare( <binary-array>, <offset>, <needle, <needleOffset>, <length>, <ignoreCase> )

Description

Compare two binary variables.

Parameters

binary-array

The a binary variable to use.

offset

Optional; Start position to begin comparing. (0 = first byte)

If the start is a negative value the byte position will work backwards from the length of the shortest binary variable.

needle

The a binary variable to be comparing to.

needleOffset

Optional; Start position to begin comparing in the needle. (0 = first byte)

length

Optional; Maximal number of bytes to compare. By default the entire remainder of the shortest binary variable.

If length is given and is negative, then the compare will begin with many bytes will be omitted from the end of shortest binary variable (after the offset position has been calculated when a offset is negative).

If offset denotes the position of this truncation or beyond, failure will be returned ( -2 ).

ignoreCase

Optional; if true the comparison is case-insensitive

Return Value

-1 if binary1 is less than binary2

1 if binary1 is greater than binary2

0 if they are equal.

-2 on error

Remarks

If ignoreCase is true, the result is equivalent to performing a case-sensitive comparison after converting the uppercase ASCII letters A-Z in both binary variables to lowercase.

Example

my $Binary1 = Pack("A*", "Hello world!!!");
my $Binary2 = Pack("A*", "Hello world!!!");
 
If( BinaryCompare($Binary1, 0, $Binary2) == 0 )
{
	println("Both binary variables contain the same data");
}
Else
{
	println("No match");
}
 
println("");
println("Lets try again now now that one was changed");
my $Binary1 = Pack("A*", "Test");
If( BinaryCompare($Binary1, 0, $Binary2) == 0 )
{
	println("Both binary variables contain the same data");
}
Else
{
	println("No match");
}

Check from the 4th byte to the 6th byte

my $Binary1 = Pack("A*", "TheFoXok");
my $Binary2 = Pack("A*", "DatFoXNP");
 
If( BinaryCompare($Binary1, 0, $Binary2, 3, 3) == 0 )
{
	println("Both binary variables contain the same data");
}
Else
{
	println("No match");
}